User manual

15
1.10 Memory Installation Procedures
To install DIMMs, first make sure the two handles of the DIMM socket
are in the "open" position. i.e. The handles lean outward. Slowly slide the
DIMM module along the plastic guides on both ends of the socket. Then
press the DIMM module right down into the socket, until you hear a
click. This is when the two handles have automatically locked the mem-
ory module into the correct position of the DIMM socket. To remove the
memory module, just push both handles outward, and the memory mod-
ule will be ejected by the mechanism in the socket.
Table 1.5: Memory Configuration
Quantity of
Memory modules
Location
(DIMM No.)
Memory
Type
Channel
Type
One module Either A2 or B2 Non-Limited Single
Two modules (A1+A2) or
(B1+B2)
Non-Limited Single
Two modules Only A2 + B2 Same Type Dual
Three modules Not Recommend -- --
Four modules (A2+B2) and
(A1+B1)
A2=B2 and
A1=B1
Dual