User manual
Table Of Contents
- PCA-6011
- Contents
- 1 Hardware Configuration
- 1.1 Introduction
- 1.2 Features
- 1.3 Specifications
- 1.4 Jumpers and Connectors
- 1.5 Board Layout: Jumper and Connector Locations
- 1.6 PCA-6011 Block Diagram
- 1.7 Safety Precautions
- 1.8 Jumper Settings
- 1.9 System Memory
- 1.10 Memory Installation Procedures
- 1.11 Cache Memory
- 1.12 Processor Installation
- 1.13 Power Model Setting and Installation
- 1.14 ATX Mode
- 2 Connecting Peripherals
- 2.1 Introduction
- 2.2 IDE Connectors (IDE1)
- 2.3 Floppy Drive Connector (FDD1)
- 2.4 Parallel Port (LPT1)
- 2.5 VGA Connector (VGA1)
- 2.6 Serial Ports (COM1, COM2)
- 2.7 PS/2 Keyboard and Mouse Connector (KBMS1)
- 2.8 External Keyboard & Mouse (KBMS2)
- 2.9 CPU Fan Connector (CPUFAN1)
- 2.10 Front Panel Connectors (JFP1, JFP2, JFP3)
- 2.11 H/W Monitor Alarm (JOBS1)
- 2.12 LAN RJ45 connector (LAN1/LAN2)
- 2.13 HD Link connector (HDAUD1)
- 2.14 Serial ATA2 Interface (SATA1 ~ SATA4)
- 2.15 LAN LED connector (LAN LED1)
- 2.16 USB (USB12, USB34, USB56, USB78)
- 2.17 Case open (JCASE1)
- 3 AMI BIOS Setup
- 3.1 Introduction
- 3.2 Entering Setup
- 3.2.1 Main Setup
- 3.2.2 Advanced BIOS Features Setup
- 3.2.3 PCI/PNP Setup
- 3.2.4 Boot Settings
- 3.2.5 Security Settings
- 3.2.6 Advanced Chipset Settings
- 3.2.7 Exit Options
- 4 Chipset Software Installation Utility
- 5 VGA Setup
- 6 LAN Configuration
- A Programming the Watchdog Timer
- B I/O Pin Assignments
- B.1 IDE Hard Drive Connector (IDE1)
- B.2 Floppy Drive Connector (FDD1)
- B.3 Parallel Port Connector (LPT1)
- B.4 VGA Connector (VGA1)
- B.5 RS-232 Serial Port (COM1, COM2)
- B.6 PS/2 Keyboard/Mouse Connector (KBMS1)
- B.7 External Keyboard Connector (KBMS2)
- B.8 CPU Fan Power Connector (CPUFAN1)
- B.9 Power LED and Keyboard Lock Connector (JFP3 / PWR_LED & KEY LOCK)
- B.10 External Speaker Connector (JFP2 / SPEAKER)
- B.11 Reset Connector (JFP1 / RESET)
- B.12 HDD LED (JFP2 / HDDLED)
- B.13 ATX Soft Power Switch (JFP1 / PWR_SW)
- B.14 SM Bus Connector (JFP2/SNMP)
- B.15 HD Link connector (HDAUD1)
- B.16 LAN LED Connector (LAN LED1)
- B.17 AT Power Connector (ATXF1)
- B.18 H/W Monitor Alarm (JOBS1)
- B.19 USB Connector (USB12, USB34, USB56, USB78)
- B.20 Case Open Connector (JCASE1)
- B.21 GPIO Pin Header (GPIO1)
- B.22 System I/O Ports
- B.23 DMA Channel Assignments
- B.24 Interrupt Assignments
- B.25 1st MB Memory Map
- B.26 PCI Bus Map

PCA-6011 User Manual viii
2.11 H/W Monitor Alarm (JOBS1)................................................................... 22
Table 2.2: Hardware Monitor Alarm setting............................... 22
2.12 LAN RJ45 connector (LAN1/LAN2) ........................................................ 22
2.13 HD Link connector (HDAUD1) ................................................................ 23
2.14 Serial ATA2 Interface (SATA1 ~ SATA4)................................................ 23
2.15 LAN LED connector (LAN LED1)............................................................ 24
Table 2.3: Front Panel LAN indicator connector ....................... 24
2.16 USB (USB12, USB34, USB56, USB78).................................................. 25
2.17 Case open (JCASE1).............................................................................. 25
Chapter 3 AMI BIOS Setup................................. 27
3.1 Introduction ............................................................................................. 28
Figure 3.1 Setup Program Initial Screen ................................... 28
3.2 Entering Setup ........................................................................................ 29
3.2.1 Main Setup.................................................................................. 29
Figure 3.2 Main Setup Screen................................................... 29
3.2.2 Advanced BIOS Features Setup................................................. 30
Figure 3.3 Advanced BIOS Features Setup Screen.................. 30
Figure 3.4 CPU Configuration Settings ..................................... 30
Figure 3.5 IDE Configuration..................................................... 31
Figure 3.6 Super I/O Configuration............................................ 32
Figure 3.7 Hardware Health Configuration................................ 33
Figure 3.8 APM Configuration ................................................... 34
Figure 3.9 MPS Configuration ................................................... 35
Figure 3.10Smbios Configuration............................................... 35
3.2.3 PCI/PNP Setup........................................................................... 37
Figure 3.11PCI/PNP Setup_1..................................................... 37
Figure 3.12PCI/PNP Setup_2..................................................... 37
3.2.4 Boot Settings .............................................................................. 39
Figure 3.13 Boot Settings........................................................... 39
Figure 3.14Boot Settings Configuration...................................... 39
3.2.5 Security Settings......................................................................... 40
Figure 3.15Security Settings ...................................................... 40
3.2.6 Advanced Chipset Settings......................................................... 41
Figure 3.16Advanced Chipset Settings ...................................... 41
Figure 3.17North Bridge Configuration....................................... 41
Figure 3.18Video Function Configuration................................... 42
Figure 3.19 South Bridge Chipset Configuration........................ 43
3.2.7 Exit Options ................................................................................ 44
Figure 3.20Exit Options.............................................................. 44
Chapter 4 Chipset Software Installation Utility 47
4.1 Before You Begin.................................................................................... 48
4.2 Introduction ............................................................................................. 48
4.3 Windows XP Driver Setup....................................................................... 49
Chapter 5 VGA Setup ......................................... 53
5.1 Introduction ............................................................................................. 54
5.2 Preparation for VGA Driver Setup........................................................... 54
5.3 Windows XP Driver Setup....................................................................... 56
Chapter 6 LAN Configuration............................ 59
6.1 Introduction ............................................................................................. 60










