User's Manual

6
d. The equipment does not work well or you cannot get it to work according to
user manual.
e. The equipment has been dropped and damaged.
f. The equipment has obvious signs of breakage.
16. CAUTION: The computer is provided with a battery-powered real-time clock
circuit. There is a danger of explosion if battery is incorrectly replaced.
Replace only with same or equivalent type recommended by the manufacture.
Discard used batteries according to the manufacturer’s instructions.
17. If your computer is losing time significantly or the BIOS configuration resets
itself to the default, the battery may have no power.
Caution! 1. Do not replace battery yourself. Please contact a
qualified technician or your retail provider.
2. The computer is provided with a battery-powered real-time clock
circuit. There is a danger of explosion if battery is incorrectly
replaced. Replace only with same or equivalent type recommended by the
manufacturer. Discard used batteries according to the manufacturer's
instructions.
18. CLASSIFICATION:
Supply Class I adapter
No applied part
Continuous Operation
Not AP or APG category
19. Disconnect device: disconnect the power cord and battery to fully power off
the device
20. Do not place the power cord where it is difficult to disconnect and may be
stepped by other persons.
21. Follow national, state or local requirements to dispose of unit.
22. Maintenance: to properly maintain and clean the surfaces, use only the
approved products or clean with a dry applicator.
23. Contact information:
No.1, Alley 20, Lane 26, Rueiguang Road Neihu District, Taipei, Taiwan 114,
R.O.C.
TEL: [phone]
24.
25. This equipment shall not be used as a life support system.
26. Accessory equipment connected to the analog and digital interfaces must be in
compliance with the respective nationally harmonized IEC standards (i.e. IEC
60950 for data processing equipment, IEC 60065 for video equipment, IEC
61010-1 for laboratory equipment, and IEC 60601-1 for medical equipment.)
Furthermore all configurations shall comply with the system standard IEC
60601-1-1. Anyone who connects additional equipment to the signal input part