User's Manual

Declaration of Conformity

CE Conformity Statement

Radio products with the CE alert marking comply with the RED Directive

(2014/53/EU) issued by the Commission of the European Community. Compliance

with this directive implies conformity to the following European Norms (in brackets

are the equivalent international standards).

• EN 62368-1 (IEC62368-1) - Product Safety

• EN 300 328 Technical requirement for radio equipment

• EN 301 893 Technical requirement for radio equipment

• ET S301 489 General EMC requirements for radio equipment

Products that contain the radio transmitter are labeled with CE alert marking and

may also carry the CE logo.

FCC Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

1. This device may not cause harmful interference;

2. This device must accept any interference received, including interference that

may cause undesired operation.

The WLAN & BT function of this product uses a certified module and according to

FCC regulations contains RF module FCC ID : PPD-QCNFA364AH , IC :

4104A-QCNFA364A or FCC ID : TX2-RTL8822CE , IC : 6317A-RTL8822CE.

CAUTION!

Exposure to Radio Frequency Radiation.

The radiated output of this device is far below the

FCC radio frequency exposure limits. Nevertheless,

the device shall be used in such a manner that the

potential for human contact during normal

operation is minimized. When connecting an

external antenna to the device, the antenna shall be

placed in such a manner to minimize the potential

for human contact during normal operation. This

transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter.

For body worn operation, this device has been

tested and meets FCC RF exposure guidelines. When