User's Manual
FCCID:M82MITW101
16
2.1 Installing the Rubber Bumpers (Optional)
To protect the housing case of MIT-W101, install the rubber bumpers.
1. Install the rubber bumpers on the left and right side of the MIT-W101.
2. Make sure the rubber bumpers are aligned and locked on the indents.
3. Screw the rubber bumpers on left and right properly into the MIT-W101.
The Rubber bumper could provide well drop protection
when device fall from high place. Please assure the
rubber was put on the right position and the screws was
fastened when install the bumper on device.