User manual

MIC-3392 Rev.2 User Manual 48
3.3.11 Serial over LAN
The MIC-3392 supports Serial over LAN (SOL). This can be used for implementing a
virtual remote serial terminal to enable user or remote software interaction with serial
interfaces for operating system and management services. SOL is implemented as a
payload type under the IPMI v2.0 “RMCP”+ protocol.
Note! A chassis intruder sensor is not used on the MIC-3392 platform.
Power failure sensor type "C0h" indicates a power failure event.
Apart from the following list of sensors, other sensors should be reinitial-
ized when the system is powered on or reset.
- VCC
- SEL Fullness
- System PWR monitor
- Watchdog
Table 3.13: Threshold values of sensors
Sensor Name
Sensor
Number UNR UC UNC
Nominal
Reading LNC LC LNR
W83627DHG Vcore 0x10 N/A 1.44 N/A 1.2 N/A 0.8 N/A
W83627DHG +1.5 V 0x11 N/A 1.575 N/A 1.5 N/A 1.425 N/A
W83627DHG +3.3 V 0x12 N/A 3.63 N/A 3.3 N/A 2.97 N/A
W83627DHG +12 V 0x13 N/A 13.2 N/A 12 N/A 10.8 N/A
W83627DHG +1.8 V 0x14 N/A 1.98 N/A 1.8 N/A 1.62 N/A
W83627DHG +5 V 0x15 N/A 5.5 N/A 5 N/A 4.5 N/A
W83627DHG +3.3 VB 0x16 N/A 3.63 N/A 3.3 N/A 2.97 N/A
System Temp 0x20 55 50 N/A 35 N/A N/A N/A
CPU Temp 0x21 110 100 N/A 70 N/A N/A N/A
Table 3.14: Sensor Device Commands
Sensor Device Commands NetFn Cmd Mandatory /
Optional
Set Sensor Hysteresis S/E 0x24 O
Get Sensor Hysteresis S/E 0x25 O
Set Sensor Threshold S/E 0x26 O
Get Sensor Threshold S/E 0x27 O
Set Sensor Event Enable S/E 0x28 O
Get Sensor Event Enable S/E 0x29 O
Re-arm Sensor Events S/E 0x2a O
Get Sensor Event Status S/E 0x2b O
Get Sensor Reading S/E 0x2d M
Table 3.15: LAN Device Commands
LAN Device Commands NetFn Cmd Mandatory /
Optional