User manual

MIC-3392 User Manual 10
1.4.2 Clear CMOS (JP1)
This jumper is used to erase CMOS data and reset the system BIOS information. Fol-
low the procedures below to clear the CMOS.
1. Turn off the system.
2. Close jumper JP1 (1-2) for about 3 seconds.
3. Set jumper JP1 as Normal.
4. Turn on the system. The BIOS is reset to its default setting.
1.4.3 Switch Settings
SW5-1 selects the LAN port that is used for Serial Over LAN (SoL) functionality. The
10/100 LAN3 port is routed to the rear I/O but is not currently implemented on stan-
dard Advantech Rear I/O modules.
SW5-2 selects the routing of SATA channel 0 to either the onboard HDD socket or
Rear IO module.
Table 1.9: JP1 Clear CMOS
Default Normal open
Clear CMOS closed
Table 1.10: SW5-1 LAN for BMC
Default LAN2 on
LAN3 (reserved) off
Table 1.11: SW5-2 SATA HDD channel setting (single PMC)
Default On board on
RTM off
Table 1.12: SW5-2 SATA HDD channel setting (dual PMC)
Default RTM on