User manual

ix MIC-3392MIL User Manual
Figure 2.16Password configuration ............................................ 36
2.8 Advanced Chipset Settings ..................................................................... 37
Figure 2.17Advanced chipset setting.......................................... 37
2.8.1 North Bridge Chipset Configuration ............................................ 37
Figure 2.18North bridge chipset configuration............................ 37
Figure 2.19Video function configuration ..................................... 38
2.8.2 South Bridge Chipset Configuration............................................ 39
Figure 2.20South bridge chipset configuration ........................... 39
2.9 Exit Option............................................................................................... 40
Figure 2.21Exit options ............................................................... 40
2.9.1 Save Changes and Exit .............................................................. 40
2.9.2 Discard Changes and Exit .......................................................... 40
2.9.3 Load Defaults.............................................................................. 40
Chapter 3 Pre-heat for the MIC-3392MILC ........41
3.1 Introduction ............................................................................................. 42
Figure 3.1 Pre-heat thermal sensor (DS1631AU) location ........ 42
Figure 3.2 Pin definitions of CN13 ............................................. 43
3.2 Pre-heat Firmware Operation.................................................................. 43
3.2.1 Standard Pre-heat Mode............................................................. 43
3.2.2 Extended Pre-heat Mode ............................................................ 44
3.2.3 BMC Communication Interface to the x86 System ..................... 44
Table 3.1: Internal register map for the pre-heat firmware control-
ler.............................................................................. 45
3.2.4 Read/Write the Internal Registers............................................... 46
Figure 3.3 Set-up for read/write access to the internal registers46
3.2.5 Illustration of Accessing an Internal Register of BMC................. 47
Figure 3.4 <Enter> “debug32” utility .......................................... 47
Chapter 4 IPMI for the MIC-3392MILS................51
4.1 Introduction ............................................................................................. 52
4.2 Definitions ............................................................................................... 52
4.3 IPMI Function List ................................................................................... 53
4.3.1 IPMI Device Global Commands.................................................. 53
Table 4.1: Supported IPMI device global commands ................ 53
4.3.2 BMC Device and Messaging Interfaces...................................... 53
Table 4.2: H8S I2C bus connection to NIC SMBus ................... 53
Table 4.3: NIC interrupt ............................................................. 53
Table 4.4: BMC device and messaging commands .................. 54
4.3.3 BMC Watchdog Timer Commands ............................................. 54
Table 4.5: BMC watchdog timer commands.............................. 54
4.3.4 Chassis Device Commands........................................................ 55
Table 4.6: Chassis device commands....................................... 55
4.3.5 Event Commands ....................................................................... 55
Table 4.7: Event commands...................................................... 55
4.3.6 PEF and Alerting Commands ..................................................... 55
Table 4.8: PEF and alerting commands .................................... 55
4.3.7 SEL Device Commands.............................................................. 56
Table 4.9: SEL device commands............................................. 56
4.3.8 SDR Device Commands ............................................................. 56
Table 4.10: SDR device commands ............................................ 56
4.3.9 FRU Data .................................................................................... 56
Table 4.11:FRU device commands ............................................ 56
4.3.10 Sensor and Threshold Configuration .......................................... 57
Table 4.12:Sensors list ............................................................... 57
Table 4.13:Threshold values of sensors..................................... 58
Table 4.14: Sensor device commands ........................................ 58