User manual

MIC-3392MIL User Manual 28
2.4.4 Super I/O Configuration
Figure 2.8 Super I/O configuration
! Onboard Floppy Controller: Used to enable or disable the on-board floppy
controller (in the Super I/O).
! Floppy Drive Swap: Set this option to “Enabled” to specify that floppy drives A:
and B: are swapped. The setting can be “Enabled” or “Disabled”.
! Serial Port1 Address: Used to select Serial Port1 base addresses.
! Serial Port2 Address: Used to select Serial Port2 base addresses.
! Serial Port2 Mode: Used to select mode for Serial Port2.
! Parallel Port Address: Used to select Parallel Port base addresses.
! Parallel Port Mode: Used to select Parallel Port mode.
! Parallel Port IRQ: Used to select Parallel Port IRQ.