User manual

MIC-3392MIL User Manual 16
Figure 1.6 Remove the PCB guide bases from the conduction-cooled plate
1.7.3 Conduction-Cooled Plate Removal
To gain access to the CF socket (CN10), the conduction-cooled plate must be
removed. There are sixteen M2.5 screws to be removed before the plate can be
retrieved. Caution must be taken when taking the plate away from the PCB because
the heater pad’s power input wire is still connected to connector CN13.
Figure 1.7 Remove the M2.5 screws from the secondary side of the PCB