User manual

11 MIC-3392MIL User Manual
Chapter 1 Hardware Configuration
SW3 selects the routing of SATA port 1 channel to either the onboard HDD socket or
the RTM.
COM3 on the RIO-3392MIL RTM is connected to the BMC. The BMC firmware can
be re-programmed by setting SW4 to “BMC Firmware Programmable” mode. For
BMC OOB (out-of-band) support, the default setting of SW4 needs to be resumed.
Table 1.11: SW3 SATA Port 1 Channel Setting
Default
On-Board
On
RTM
Off
Table 1.12: SW4 BMC Firmware Programming/Console Setting
Default
BMC to Console
Off On Off On Off Off
BMC Firmware Programmable
On Off On Off On On