User manual

MIC-3392MIL User Manual 10
2. Close jumper JP6 (1-2) for about 3 seconds.
3. Set jumper JP6 as Normal.
4. Turn on the system. The BIOS is reset to its default setting.
1.4.3 Switch Settings
Table 1.8: JP6 Clear CMOS
Default Normal Open
Clear CMOS Closed
12
12
Table 1.9: SW1 PCI Bridge Master/Drone Mode Selection
Default
Master
On On
Drone
Off Off
Note!
Key: represents the switch.
Table 1.10: SW2 BMC Reset/Platform Reset (available on the Front
Panel only)
SW2 (top) BMC Reset
SW2 (bottom) Platform Reset