User`s manual

53 Chapter 4
Quick Power On Self Test
This category speeds up Power On Self Test (POST) after you power on
the computer. If this is set to Enabled, BIOS will shorten or skip some
check items during POST.
First/Second/Third Boot Device and Boot Other Device
The BIOS attempts to load the operating system from the devices in the
sequence selected in these items. The settings are Floppy, LS120, HDD-
0, SCSI, CDROM, HDD-1, HDD-2, HDD-3, ZIP100, USB-FDD, USB-
ZIP, USB-CDROM, USB-HDD, LAN and Disabled.
Swap Floppy Drive
Switches the floppy disk drives between being designated as A and B.
Default is Disabled.
Boot Up Floppy Seek
During POST, BIOS will determine if the floppy disk drive installed is 40
or 80 tracks. 360K type is 40 tracks while 760K, 1.2M and 1.44M are all
80 tracks. Default is Enabled.
Boot Up NumLock Status
The default value is On.
Enabled (default) Enable quick POST
Disabled Normal POST
Default
First boot device Floppy
Second boot device HDD-0
Third boot device CD-ROM
NOTE: When you boot by USB CD-ROM, please install
WinXP with SP1 or Win 2000 with SP3.
On (default) Keypad is numeric keys.
Off Keypad is arrow keys.