User`s manual

3 Chapter 1
MIC-3369C can also operate a peripheral slot in drone mode, so that the
peripheral card functions as a stand-alone computer and does not commu-
nicate on the CompactPCI bus.
PMC (PCI Mezzanine Card) IEEE1386.1 Compliant
The MIC-3369C supports one PMC site and compliant with PICMG 2.3
(PCI Mezzanine Card) specification. This 64-bit/66MHz PMC interface
provides front access capability by PMC modules for various functions.
Complete I/O Functions
The MIC-3369C offers all the I/O functions of an industrial computer
with the rugged Eurocard form factor. The rest of I/O have fully con-
nected to the rear I/O module via user-defined connectors (J3 and J5) on
the backplane. This I/O module contains one Gigabit Ethernet port, one
RJ-45 COM port, two USB 2.0 ports, one VGA connector, and one PMC
site. The front panel also has a reset button and LEDs for hot swap indica-
tion, power status, HDD operation and Ethernet communication. The
built-in high speed IDE controller provides two separate IDE channels
with Ultra DMA/33/66/100 mode. The user-defined J3 connector is
designed to support two IDE devices, one floppy disk drive, one parallel
port device, LAN 1/2 for PICMG 2.16. These drives can simply be con-
nected to the backplane or to the rear transition board for easy service and
maintenance.
Meets switch-fabric, mission critical and computing intensive appli-
cations requirements
Supporting the PICMG 2.16 specification, it is an ideal platform for the
emerging switch-fabric applications blade server, mission critical and
computing intensive applications such as third-generation (3G) wireless,
voice over Internet protocol (VoIP), networking, image processing, and
other demanding telecom/data communication applications
The two-layer front panel design complies with IEEE 1101.10. Connec-
tors are firmly screwed to the front panel, and the replaceable shielding
gasket is attached to the panel edge. This reduces emissions and gives
better protection against external interference. A watchdog timer can
automatically reset the system if the system stops abnormally.