Installation guide
Table Of Contents
- About This Publication
- Document Revision History
- 1. Post-Release Developments
- 1.1 Service Update for Dialogic® System Release 6.1 CompactPCI for Windows®
- 1.2 PDK Support for Automatic Answer and Reject of Inbound Calls
- 1.3 Status Monitor Tool Support for 16 Span Boards
- 1.4 Improvement to Call Progress Analysis
- 1.5 Media Load Support for the Dialogic® DM/V1200A- 4E1-cPCI Board
- 1.6 Handling non-2xx Responses to T.38 Switch
- 1.7 Important Notice about System Release Update Installation
- 1.8 Media LAN Disconnection Alarm Notification for Dialogic® DM/IP Boards
- 1.9 Support for SFTP in Dialogic® Global Call SS7 Call Control Library
- 1.10 New Media Loads for Dialogic® DM/V4800BC Media Boards Using Special Coders
- 1.11 File Management Enhancements for DebugAngel Tool
- 1.12 File Management Enhancements for PDK Trace Tool
- 1.13 Configuring SIP Stack Parameters with Global Call
- 1.14 Disabling Automatic re-INVITE Message when Switching between Fax and Audio
- 1.15 IP Multicast Client Support
- 1.16 Troubleshooting Information for RTF Logs
- 1.17 Remote Diagnostics Package
- 1.18 Enhanced Diagnostics Tools
- 1.19 New QoS Alarms for RTCP and RTP Inactivity
- 1.20 New Operating System Support
- 1.21 Support for Compute Platforms
- 1.22 New Parameter for Adjusting Silence Threshold on Dialogic® DM3 Boards
- 1.23 File Management Enhancements for ISDNtrace Tool
- 1.24 New Media Loads for Dialogic® DM/V2400A-cPCI and DM/V4800BC Media Boards
- 1.25 Modified Alarm Events for Media LAN Disconnect
- 1.26 Enhancement to its_sysinfo Tool
- 1.27 Modify an Existing SIP Call Using re-INVITE for Dialogic® IPT Boards
- 1.28 PDK Log File Detection
- 1.29 Media Channel Reset Capability (Stuck IP Media Channel Recovery)
- 1.30 Dialogic® Global Call API Access to New H.323/Q.931 Message IEs
- 1.31 On-Demand Full Reset of Dialogic® DM3 Boards
- 1.32 New Dialogic® Diagnostics Management Console
- 1.33 New Runtime Trace Facility (RTF) Manager
- 1.34 Support for Reporting Billing Type
- 1.35 Runtime Control of Double Answer for R2MF
- 1.36 Additional Supported Operating System Security Updates
- 1.37 Media Channel Reset Capability (Stuck Channel Recovery)
- 1.38 Notification of Layer 1 Alarm Events on Dialogic® SS7 Boards
- 1.39 Dialogic® Global Call Support for Time Slots on Dialogic® SS7 Boards Running in DTI Mode
- 2. Release Issues
- 3. Documentation Updates
- 3.1 System Release Documentation Updates
- 3.2 Installation and Configuration Documentation Updates
- 3.2.1 Dialogic® System Release 6.1 CompactPCI for Windows® Software Installation Guide
- 3.2.2 Dialogic® DM3 Architecture for CompactPCI on Windows® Configuration Guide
- 3.2.3 Dialogic® IPT Series on Windows® Configuration Guide
- 3.2.4 Dialogic® Global Call Country Dependent Parameters (CDP) for PDK Protocols Configuration Guide
- 3.3 OA&M Documentation Updates
- 3.3.1 Dialogic® System Release 6.1 CompactPCI for Windows® Administration Guide
- 3.3.2 Dialogic® SNMP Agent Software for Windows® Administration Guide
- 3.3.3 Dialogic® System Software Diagnostics Guide
- 3.3.4 Dialogic® Board Management API Library Reference
- 3.3.5 Dialogic® Event Service API Programming Guide
- 3.3.6 Dialogic® Event Service API Library Reference
- 3.3.7 Dialogic® Native Configuration Manager API Programming Guide
- 3.3.8 Dialogic® Native Configuration Manager API Library Reference
- 3.4 Programming Libraries Documentation Updates
- 3.4.1 Dialogic® Audio Conferencing API Programming Guide
- 3.4.2 Dialogic® Audio Conferencing API Library Reference
- 3.4.3 Dialogic® Continuous Speech Processing API Programming Guide
- 3.4.4 Dialogic® Continuous Speech Processing API Library Reference
- 3.4.5 Dialogic® Digital Network Interface Software Reference
- 3.4.6 Dialogic® Fax Software Reference
- 3.4.7 Dialogic® Global Call API Programming Guide
- 3.4.8 Dialogic® Global Call API Library Reference
- 3.4.9 Dialogic® Global Call E1/T1 CAS/R2 Technology Guide
- 3.4.10 Dialogic® Global Call IP Technology Guide
- 3.4.11 Dialogic® Global Call ISDN Technology Guide
- 3.4.12 Dialogic® Global Call SS7 Technology Guide
- 3.4.13 Dialogic® IP Media Library API Programming Guide
- 3.4.14 Dialogic® IP Media Library API Library Reference
- 3.4.15 Dialogic® Modular Station Interface API Programming Guide
- 3.4.16 Dialogic® Modular Station Interface API Library Reference
- 3.4.17 Dialogic® Standard Runtime Library API Programming Guide
- 3.4.18 Dialogic® Standard Runtime Library API Library Reference
- 3.4.19 Dialogic® Voice API Programming Guide
- 3.4.20 Dialogic® Voice API Library Reference
- 3.5 Demonstration Software Documentation Updates
- 3.5.1 Dialogic® Continuous Speech Processing API Demo Guide
- 3.5.2 Dialogic® Global Call API Demo Guide
- 3.5.3 Dialogic® High Availability for Windows® Demo Guide
- 3.5.4 Dialogic® IP Gateway (Global Call) Demo Guide
- 3.5.5 Dialogic® IP Media Server (Global Call) Demo Guide
- 3.5.6 Dialogic® IP Media Gateway (IPML) Demo Guide
Dialogic
®
System Release 6.1 CompactPCI for Windows
®
Release Update
Copyright and Legal Notice
Copyright © 2005-2012, Dialogic Inc.. All Rights Reserved. You may not reproduce this document in whole or in part without permission in writing from Dialogic
Inc. at the address provided below.
All contents of this document are furnished for informational use only and are subject to change without notice and do not represent a commitment on the part of
Dialogic Inc. and its affiliates or subsidiaries (“Dialogic”). Reasonable effort is made to ensure the accuracy of the information contained in the document.
However, Dialogic does not warrant the accuracy of this information and cannot accept responsibility for errors, inaccuracies or omissions that may be contained
in this document.
INFORMATION IN THIS DOCUMENT IS PROVIDED IN CONNECTION WITH DIALOGIC® PRODUCTS. NO LICENSE, EXPRESS OR IMPLIED, BY
ESTOPPEL OR OTHERWISE, TO ANY INTELLECTUAL PROPERTY RIGHTS IS GRANTED BY THIS DOCUMENT. EXCEPT AS PROVIDED IN A SIGNED
AGREEMENT BETWEEN YOU AND DIALOGIC, DIALOGIC ASSUMES NO LIABILITY WHATSOEVER, AND DIALOGIC DISCLAIMS ANY EXPRESS OR
IMPLIED WARRANTY, RELATING TO SALE AND/OR USE OF DIALOGIC PRODUCTS INCLUDING LIABILITY OR WARRANTIES RELATING TO FITNESS
FOR A PARTICULAR PURPOSE, MERCHANTABILITY, OR INFRINGEMENT OF ANY INTELLECTUAL PROPERTY RIGHT OF A THIRD PARTY.
Dialogic products are not intended for use in medical, life saving, life sustaining, critical control or safety systems, or in nuclear facility applications.
Due to differing national regulations and approval requirements, certain Dialogic products may be suitable for use only in specific countries, and thus may not
function properly in other countries. You are responsible for ensuring that your use of such products occurs only in the countries where such use is suitable. For
information on specific products, contact Dialogic Inc. at the address indicated below or on the web at www.dialogic.com.
It is possible that the use or implementation of any one of the concepts, applications, or ideas described in this document, in marketing collateral produced by or
on web pages maintained by Dialogic may infringe one or more patents or other intellectual property rights owned by third parties. Dialogic does not provide any
intellectual property licenses with the sale of Dialogic products other than a license to use such product in accordance with intellectual property owned or validly
licensed by Dialogic and no such licenses are provided except pursuant to a signed agreement with Dialogic. More detailed information about such intellectual
property is available from Dialogic’s legal department at 926 Rock Avenue, San Jose, California 95131 USA. Dialogic encourages all users of its products to
procure all necessary intellectual property licenses required to implement any concepts or applications and does not condone or encourage any intellectual
property infringement and disclaims any responsibility related thereto. These intellectual property licenses may differ from country to country and it is the
responsibility of those who develop the concepts or applications to be aware of and comply with different national license requirements.
Dialogic, Dialogic Pro, Dialogic Blue, Veraz, Brooktrout, Diva, Diva ISDN, Making Innovation Thrive, Video is the New Voice, Diastar, Cantata, TruFax, SwitchKit,
SnowShore, Eicon, Eicon Networks, NMS Communications, NMS (stylized), Eiconcard, SIPcontrol, TrustedVideo, Exnet, EXS, Connecting to Growth, Fusion,
Vision, PowerMedia, PacketMedia, BorderNet, inCloud9, I-Gate, Hi-Gate, NaturalAccess, NaturalCallControl, NaturalConference, NaturalFax and Shiva, among
others as well as related logos, are either registered trademarks or trademarks of Dialogic Inc. and its affiliates or subsidiaries. Dialogic's trademarks may be used
publicly only with permission from Dialogic. Such permission may only be granted by Dialogic’s legal department at 926 Rock Avenue, San Jose, California 95131
USA. Any authorized use of Dialogic's trademarks will be subject to full respect of the trademark guidelines published by Dialogic from time to time and any use of
Dialogic’s trademarks requires proper acknowledgement. The names of actual companies and products mentioned herein are the trademarks of their respective
owners. This document discusses one or more open source products, systems and/or releases. Dialogic is not responsible for your decision to use open source
in connection with Dialogic products (including without limitation those referred to herein), nor is Dialogic responsible for any present or future effects such usage
might have, including without limitation effects on your products, your business, or your intellectual property rights.
Microsoft, Windows, Windows Server and Windows 7 are registered trademarks of Microsoft Corporation in the United States and/or other countries. Other names of actual
companies and product mentioned herein are the trademarks of their respective owners. Other names of actual companies and product mentioned herein are the trademarks
of their respective owners.
Publication Date: June 11, 2012
Document Number: 05-2514-057