Installation guide

Dialogic
®
System Release 6.1 CompactPCI for Windows
®
Release Update 135
Update to Section 4.3, Starting the Configuration Manager (DCM)
In the instructions regarding the Computer Name dialog box for remote DCM, the
following note should be added:
Note: In order to use remote DCM, the local computer (management node) and
remote computer (managed node) must both be running the same Dialogic
®
software release (for example, System Release 6.1 CompactPCI Windows)
and same build number. If you try to connect to a remote computer with a
different software release or build number, the following message is
displayed:
An incompatible version of the Dialogic(R) System Release
Software is installed on the remote system
and the software releases and build numbers for the two systems are shown.
Update to Section 5.12, Trunk Configuration Property Sheet
The Guidelines at the end of the section (for Trunk1 to Trunk16 parameters) should
be updated as follows (new information is shown in bold):
Guidelines: You can assign different T1 and E1 protocols from the above lists to
different trunks on the same board provided the protocols are all from the same
group. The following values are for Clear Channel signaling: E1CC, ISDNE1CC,
T1CC, and ISDNT1CC. It is recommended to use ISDNE1CC or ISDNT1CC if
mixing ISDN and Clear Channel trunks on the same board. Similarly, use E1CC
or T1CC if mixing a PDK (CAS or R2MF) protocol with Clear Channel signaling
on the same board. After assigning T1 or E1 protocols, use the PDK Configuration
property sheet to assign country dependent parameter files if applicable.
Update to Section 6.8, [0x3b] Parameters
Information about parameters 0x3b03 and 0x3b04 should be added to this section as
follows:
Note: This information is intended for experienced users of the DM3 conferencing
feature. Changing the default parameter settings is not recommended, as
this could introduce negative effects on the audio quality and conferencing
experience of the participants.
CSUMS_ActTalkerPartiesMinNum
Number: 0x3b03
Description: Specifies the number of talkers in a conference before Active Talker mode is enabled.
Note: Conference Active Talker mode, though related, should not be confused with the Active Talker
detection feature.
Values: 0 [default] to 0xff (255).
Guidelines: Refer to the guidelines for the CSUMS_SmartScalingPartiesMinNum parameter
below.