User Manual Part 2

155 Appendix A
A.1.2 Decoder setup
Functions:
Item Explanation
No Read
Timeout
Maximum time (in milliseconds) that the imager
attempts to decode before declaring a “No Decode”
condition. If attempting to decode using the trigger key,
the imager quits decode attempts even if the trigger key
remains depressed. A new decode using the trigger
can only begin after the trigger is released. The timeout
also applies to the decode operation of the imaging
technology. The Timeout range is 0, meaning no time-
out, (i.e., infinite) to 300,000.
Multiple
Symbols Mode
Enables/Disables multiple symbols decoding. Normally
the imager stops attempting to decode when a bar
code symbol is decoded. In multiple symbols mode, the
imager does not stop until the trigger is released or a
“No Decode” timeout occurs. The same bar code will
not be read again until the current decoding stops.