User Manual Part 1

55 Chapter 3
Table 3.1: Basic Explanation
Field Name Function Explanation
Beep After Scan OK
Select the number of beep tones after a suc-
cessful scan.
None
After scanning the barcode, do
not beep.
One Time
After scanning the barcode,
beep once.
Two Times
After scanning the barcode,
beep twice.
Scan Timeout
Select the scanning timeout duration (in sec-
onds) from this pull-down list.
2 ~ 20 seconds. Default: 5 seconds
Termination Code
None
After showing barcode, do not
action.
CRLF
After showing the barcode,
jump to the next row.
Space
After showing the barcode,
jump one unit.
Tab
After showing the barcode,
jump a section.
Continuous Scan
Disable Disable this functionality.
1 ~ 5 sec
The duration of a continuous
scan.
Keybd Message
Select a method based upon the barcode scan-
ning application you will use.
Type Writing
A unit follows a unit, quickly
showing the barcode number.
Copy & Paste
Show the barcode number
once.
Prefix Type the desired label prefix in this text box.
Suffix Type the desired label suffix in this text box.
Default
Press the “Default” button to reset all settings of
the “Basic” Tab to default values.
F/W ver. Decoder firmware version.
Set All To Default
Press the “Set All To Default” button to reset all
settings of the “Basic” tab, “Code Configure”
tab, “Code ID” tab and all barcodes of “Barcode
Setup” to default values.