User Manual Part 1

MARS-1030F User Manual 44
2.5.7 Scanning Barcode, 1D laser version
To use the scanning function, complete the following steps:
1. If you have not already done so, remove the protective plastic film
before using devices equipped with a laser scanner.
2. Select Start > Settings > Control Panel > Barcode Setting. Con-
figure settings as described in “Barcode Setting” on page 53.
3. Start WordPad.
4. Aim the scanning beam at the center of bar code.
– Position the device close to bar code when scanning
– Position the device further away when scanning larger bar
codes.
– The scanner is disabled after you release the key or after five
seconds.
5. Press the right/left/central scan key. The scanner scans as long as
you hold the key or for five seconds.
6. Upon reading a bar code, the red LED indicator comes on until the
trigger is release or five seconds. The green LED and the beep tone
indicate a good read.