User Manual

Table Of Contents
25 Chapter 2
2.4.2 Power on / off
To turn on the PDT
Press the Power key briefly ( ). If the PDT does not power on, perform
the cold reset. See chapter 2.7.1.
As the PDT initializes its file system, it splash screen displays for about
30 seconds followed by calibration screen. Every time you perform a cold
reset, these screens will also appear.
To turn off the PDT, just press the Power key again. This action does not
actually turn off the PDT, it only turns the PDT into suspend mode. All
running applications remain as you left them, until you press the Power
key again to resume operation of the PDT
2.4.3 Calibration of the touch Screen
Figure 2.11: Calibration
On the initial boot-up of the PDT, the
stylus calibration screen (Labeled Align
Screen) opens. Use the stylus to press and
hold briefly on the center of each target as
it moves around the screen.
If necessary, adjust the backlight on the
PDT to make the screen readable. (See
below 2.4.4. Adjust the
brightness).
When you feel the touch screen
function is poor or the operation does not
match the exact location it should be,
please recalibrate the screen by using the
stylus to tap the Start > Settings >
Control Panel > Stylus, to open the
Calibration” to
recalibrate again.