User Manual

Table Of Contents
155 Chapter A
A.1.2 Decoder Setup
Function Explaining:
Item Function Explaining
No Read
Timeout
Maximum time (in milliseconds) that the imager will
attempt to decode before declaring a “No Decode”
condition. If attempting to decode using the trigger key,
the imager quits decode attempts even if the trigger key
remains depressed. You will not be able to start a new
decode using the trigger until after the trigger is
released. The timeout also applies to the decode
operation of the imaging technology. The Timeout
range is 0 meaning no timeout (i.e., infinite) to 300,000.
Multiple
Symbols Mode
Enables/Disables multiple symbols decoding. Normally
the imager stops attempting to decode when a bar
code symbol is decoded. In multiple symbols mode, the
imager will not stop until the trigger is released or a “No
Decode” timeout occurs. The same bar code will not
read again until current decoding stops.