User manual

IPPC-8151S User Manual 10
2.4 Install Panel Mount
1. Take the mounting brackets out of IPPC-8151S accessory box.
2. Attach the four mounting brackets by inserting the screws into the
keyhole slots on the cover of the monitor.
3. Use the screws to secure the brackets to the cover. Tighten the
screws to secure the monitor to the back panel.
2.5 Installing I/O Cables
Open the cover from the rear and bottom.
Put the cables through the rear hole to the bottom.
Connect the cables through the bottom.
2.6 Install a 2.5" SATA HDD
IPPC-8151S supports one enhanced Serial Advanced Technology Attach-
ment (SATA) hard disk drive to IPPC-8151S. Please use a wide-tempera-
ture industrial hard disk to meet the thermal requirement.
1. Unscrew the back cover and open it.
2. Remove four screws and take off HDD bracket.
3. Insert the HDD into the bracket