User`s manual

16 IPC-623 User's Manual
Chapter 2 System Setup
WARNING: Before starting the installation process, make sure you disconnect all power from
the chassis. Do this by turning off the power switch and unplugging the power
cord from the power outlet. If you are not sure what to do, let an experienced
technician handle it.
2.1 Attaching the Handles
The handles for the front panel are in the accessory box. To install the handles, simpy secure them to
the front panel with the screws provided.
2.2 Removing the Top Covers
The first step is to remove the chassis cover. You will need a Philips screwdriver.
There are two top covers for the IPC-623: the front top cover and the rear top cover. Both are fixed to
the chassis with four screws, two on each side.
To remove either of the top covers:
1. Detach the four screws on the sides.
2. Lift off the cover.
IMPORTANT: Make sure you remove the front and rear top covers when maintaining
full-size cards. See table 2-1 below for further information:
IMPORTANT: Check all the power supply cables and make certain that they are not tangled
or blocking the cooling fan blades. This prevents any accidental damage to
the cables.
Component in need
of maintenance
Remove
Drive bay front top cover
Cooling fan front top cover
Half-size CPU card rear top cover
Full-size CPU card front top cover & rear top cover
Full-size I/O card front top cover & rear top cover
Alarm board rear top cover
Figure 2-1