User manual

13 Chapter 2
3. Select a vacant PICMG slot for the full-length CPU card or PCI/ISA
slot for other add-on cards and remove the corresponding I/O bracket
attached to the rear plate of the chassis.
4. Insert the CPU card or add-on card vertically into the proper slot (See
Figure 2.5 & Figure 2.6). For full-length cards, please make sure that
the card bracket has been inserted properly and the other edge of the
card has been inserted into the plastic guiding. Fasten the card by a
screw on top of the I/O bracket.
5. Repeat Step 3 and 4 if there is more than one add-on card.
6. There are two rows of notches on both sides of the hold-down clamp
for inserting the rubber cushions into. One side is for PCI cards, the
other side is for ISA cards. Depending on the card height, the cushions
can be inserted upward or downward. After the rubber cushions have
been inserted into the notches, they will stabilize the add-on cards to
protect them from shock and vibration. Use the shorter rubber cushions
to stabilize the full-length CPU cards.
7. Put back the hold-down clamp and screw it in place.
8. Replace the top rear chassis cover and fasten it.
Figure 2.4: Adjusting the location of thermal sensor