User`s manual
Table Of Contents
- Table of Contents
- Chapter 1 General Information
- 1.1 Introduction
- 1.2 Specifications
- 1.3 Dimensions
- Figure 1-1: IPC-610 dimensions
- Chapter 2 System Setup
- 2.1 Removing the Cover
- Figure 2-1: Removing the cover
- Figure 2-2: Inserting/removing the drive bay
- Figure 2-3: Inserting the drives into the drive bay
- 2.3 The Hold-down Clamp
- 2.4 Connecting the Keyboard
- Figure 2-4: Detaching the hold-down clamp
- Figure 2-6: Front keyboard connection
- Figure 2-7: Rear keyboard connection
- 2.5 Replacing the Filter
- Figure 2-8: Replacing the filter
- Appendix A Rear Cover and Window
- A.1 Changing the Rear Cover According to Power Supply Used
- Figure A-1: IPC-610 with PS/2 size power supply
- Figure A-2: IPC-610 with redundant power supply
- A.2 Changing the Rear Window of the Backplane
- Figure A-3: Rear window of IPC-610 for standard 14-slot backplane, with PS/2 size power supply
- Appendix B Exploded Diagrams
- Figure B-1: IPC-610 exploded diagram (internal components)
- Figure B-2: IPC-610 exploded diagram (case components)
- Appendix C Safety Instructions
- C.1 English
- C.2 German - Wichtige Sicherheishinweise
ii
IPC-610 User's Manual
Copyright Notice
This document is copyrighted, January 1999, by Advantech Co., Ltd. All rights are reserved.
Advantech Co., Ltd. reserves the right to make improvements to the products described in this manual
at any time without notice.
No part of this manual may be reproduced, copied, translated or transmitted in any form or by any
means without the prior written permission of Advantech Co., Ltd. Information provided in this
manual is intended to be accurate and reliable. However, Advantech Co., Ltd. assumes no respon-
sibility for its use, nor for any infringements of the rights of third parties which may result from its use.
Acknowledgments
IPC-610, PCA-6114, PCA-6114P4, PCA-6114P4R, PCA-6114P7 and PCA-6114P10 are trademarks of
Advantech Co., Ltd.
Note: The information in this document is provided for reference only. Advantech Co.,
Ltd. does not assume any liability arising out of the application or use of the
information or products described herein. This manual is subject to change
without notice.
Part No. 2002061020
8th Edition Printed in Taiwan January 1999