User`s manual
Table Of Contents
- Table of Contents
- Chapter 1 General Information
- 1.1 Introduction
- 1.2 Specifications
- 1.3 Dimensions
- Figure 1-1: IPC-610 dimensions
- Chapter 2 System Setup
- 2.1 Removing the Cover
- Figure 2-1: Removing the cover
- Figure 2-2: Inserting/removing the drive bay
- Figure 2-3: Inserting the drives into the drive bay
- 2.3 The Hold-down Clamp
- 2.4 Connecting the Keyboard
- Figure 2-4: Detaching the hold-down clamp
- Figure 2-6: Front keyboard connection
- Figure 2-7: Rear keyboard connection
- 2.5 Replacing the Filter
- Figure 2-8: Replacing the filter
- Appendix A Rear Cover and Window
- A.1 Changing the Rear Cover According to Power Supply Used
- Figure A-1: IPC-610 with PS/2 size power supply
- Figure A-2: IPC-610 with redundant power supply
- A.2 Changing the Rear Window of the Backplane
- Figure A-3: Rear window of IPC-610 for standard 14-slot backplane, with PS/2 size power supply
- Appendix B Exploded Diagrams
- Figure B-1: IPC-610 exploded diagram (internal components)
- Figure B-2: IPC-610 exploded diagram (case components)
- Appendix C Safety Instructions
- C.1 English
- C.2 German - Wichtige Sicherheishinweise
10
IPC-610 User's Manual
Appendix C Safety Instructions
C.1 English
1. Read these safety instructions carefully.
2. Keep this User's Manual for later reference.
3 . Disconnect this equipment from any AC outlet before cleaning. Do not use liquid or sprayed
detergent for cleaning. Use a moist sheet or cloth for cleaning.
4. For pluggable equipment, the socket-outlet should be installed near the equipment and should be
easily accessible.
5. Keep this equipment protected from humidity.
6. Lay this equipment on a reliable surface when installing it. A drop or fall could cause damage.
7. The openings on the enclosure are for air convection. Protect the equipment from overheating. DO
NOT COVER THE OPENINGS.
8. Make sure the voltage of the power source is correct when connecting the equipment to the power
outlet.
9. Place the power cord in such a way that people cannot step on it. Do not place anything over the
power cord.
10. All cautions and warnings on the equipment should be noted.
11. If the equipment is not used for a long time, disconnect it from the mains to prevent damage from
transient overvoltage.
12. Never pour any liquid into any opening. This could cause fire or electrical shock.
13. Never open the equipment. For safety reasons, the equipment should only be opened by qualified
service personnel.
14. If any of the following situations arises, get the equipment checked by service personnel:
a. The power cord or plug is damaged.
b. Liquid has penetrated into the equipment.
c. The equipment has been exposed to moisture.
d. The equipment does not work well or you cannot get it to work according to this User's Manual.
e. The equipment has been dropped and/or damaged.
f. The equipment has obvious signs of breakage.
15. DO NOT LEAVE THIS EQUIPMENT IN AN UNCONDITIONED ENVIRONMENT WHERE
THE STORAGE TEMPERATURE IS BELOW -20° C (-4° F) OR ABOVE 60° C (140° F). THIS
MAY DAMAGE THE EQUIPMENT.
The sound pressure level at the operator's position according to IEC 704-1:1982 is equal to or less
than 70 dB(A).
DISCLAIMER: This set of instructions is provided according to IEC 704-1. Advantech disclaims all
responsibility for the accuracy of any statements contained herein.