User`s manual
Table Of Contents
- Table of Contents
- Chapter 1 General Information
- 1.1 Introduction
- 1.2 Specifications
- 1.3 Dimensions
- Figure 1-1: IPC-610 dimensions
- Chapter 2 System Setup
- 2.1 Removing the Cover
- Figure 2-1: Removing the cover
- Figure 2-2: Inserting/removing the drive bay
- Figure 2-3: Inserting the drives into the drive bay
- 2.3 The Hold-down Clamp
- 2.4 Connecting the Keyboard
- Figure 2-4: Detaching the hold-down clamp
- Figure 2-6: Front keyboard connection
- Figure 2-7: Rear keyboard connection
- 2.5 Replacing the Filter
- Figure 2-8: Replacing the filter
- Appendix A Rear Cover and Window
- A.1 Changing the Rear Cover According to Power Supply Used
- Figure A-1: IPC-610 with PS/2 size power supply
- Figure A-2: IPC-610 with redundant power supply
- A.2 Changing the Rear Window of the Backplane
- Figure A-3: Rear window of IPC-610 for standard 14-slot backplane, with PS/2 size power supply
- Appendix B Exploded Diagrams
- Figure B-1: IPC-610 exploded diagram (internal components)
- Figure B-2: IPC-610 exploded diagram (case components)
- Appendix C Safety Instructions
- C.1 English
- C.2 German - Wichtige Sicherheishinweise
IPC-610 User's Manual
7
A.2 Changing the Rear Window of the Backplane
1. Select the backplane you want to install, such as the PCA-6114, PCA-6114P4, PCA-6114P4R,
PCA-6114P7, PCA-6114P10, etc.
2. To change the backplane's rear window, see Fig. A-3.
Figure A-3: Rear window of IPC-610 for standard 14-slot backplane, with PS/2 size power supply