User`s manual

21 Chapter 2
2.18 TV-out interface (CN2)
The PCM-9587 board provides TV-out function via CN2. This consists of
a 5-pin wafer box header. Output supports composite video, S-video and
SCART(RBG). TV-out generators use both NTSC and PAL formats.It
supports up to 1024 by 768 with full vertical and horizontal underscan
capability.
To set up your video interface run the appropriate installation program
located on the utility disk.
2.19 Ethernet configuration (CN11)
The PCM-9587 is equipped with a high performance 32-bit PCI-bus
Ethernet interface which is fully compliant with IEEE 802.3U 10/
100Mbps CSMA/CD standards. It is supported by all major network
operating systems.
The medium type can be configured via the RSET82540.EXE or
RSET82559.EXE program included on the utility disk. (See Chapter 3 for
detailed information.)
2.19.1 100Base-T connector (CN11)
10/100Base-T connects to the PCM-9587 via an adapter cable to a 10-pin
polarized header (CN11).
2.19.2 Network boot
The Network Boot feature can be utilized by incorporating the Boot
ROM image files for the appropriate network operating system. The Boot
ROM BIOS files are included in the system BIOS, which is on the utility
CD disc.
2.20 USB connectors (CN18,CN20)
The PCM-9587 board provides up to four USB (Universal Serial Bus)
1.1/2.0 ports. This gives complete Plug and Play, and hot attach/detach
for up to 127 external devices. The USB interfaces comply with USB
specification Rev. 1.1, and are fuse protected.
The PCM-9587 support three 5 x2 pin header connector for USB1,2
(CN20), USB3,4(CN18). You will need an USB cable if you use USB
connectors. The USB interfaces can be disabled in the system BIOS
setup.