Start Guide ICR-3201, ICR-3211, ICR-3231 ICR-3232, ICR-3241
Start Guide Safety Instructions Please take care to following instructions: • Use the router in compliance with national and international law and in compliance with any special or additional restrictions regulating the use of the router in the various applications and environments. • To avoid possible injury and/or damage to the device, observe the relevant provisions and standards. Use only the original accessories as recommended.
Start Guide Product Disposal Instructions The WEEE (Waste Electrical and Electronic Equipment: 2012/19/EU) directive was introduced to ensure that electrical/electronic products are recycled using the best available recovery techniques in order to minimize impact on the environment. This product contains high-quality materials and components which can be recycled. At the end of it’s life this product MUST NOT be mixed with other commercial waste for disposal. The device contains the battery.
Start Guide First Use Before applying power to the router, connect all the components that you need for your applications. A cross-shaped screwdriver is necessary to insert a SIM card. Do not run the router without an antenna connected to the main antenna connector as the energy from the transmission is effectively reflected by the open end and can damage the equipment.
Start Guide Disconnect the router from the power supply before handling the SIM card. 3. Power The router requires an external DC power supply. The DC voltage required is between +9 and +36 V DC. The router has built-in protection against reverse polarity without signaling. Connect the power supply cable to the PWR connector on the front panel of the router, see the figure below.
Start Guide 4. Ethernet For an initial configuration, made in a web browser, connect a PC by an Ethernet cable to the default LAN interface, use the ETH0 port, see the figure above. By default, this interface has the following configuration: Connector Purpose Default Setting ETH0 LAN port (default) DHCP Server Connect your PC to this port to get the router web interface. IP Address: 192.168.1.1 NetMask: 255.255.255.0 Configuration 1.
Start Guide 2. Configuration Settings via WebAccess/DMP Your router has been pre-installed with the WebAccess/DMP client. For its activation, enable it in the router’s web interface (Customization -> User Modules -> WebAccess/DMP Client). For more information see the configuration manual of your router. The activated client periodically uploads router identificators, its configuration, and cellular network statistics to the WebAccess/DMP server.
