User manual

UNO-2052E User Manual 12
Chapter 3 Initial Setup
3.1 Inserting a CompactFlash Card
The procedure for installing a CompactFlash card into the UNO-2052E is
as follows, please follows these steps carefully.
Step 1: Remove the power cord.
Step 2: Unscrew the four screws from the rear panel of the UNO-2052E.
Step 3: Remove the rear panel.
Step 4: Plug a CompactFlash card with the user’s OS and application pro-
gram into a CompactFlash card slot on the board.
Step 5: Screw back the rear panel with the four screws.
3.2 Connecting the Power
Connect the UNO-2052E to a 9~36 VDC power source. The power
source can either be from a power adapter or an in-house power source.
3.3 Connecting to a Hard Disk
The procedure for installing a hard disk into the UNO-2052E is as fol-
lows, please follows these steps carefully.
Step 1: Remove the power cord.
Step 2: Unscrew the four screws from the rear panel of the UNO-2052E.
Step 3: Remove the rear panel.
Step 4: Connect an IDE flat cable to the primary (recommended) or sec-
ondary IDE connector, then connect the other side of the connector to the
hard disk.
Step 5: Screw back the rear panel with the four screws.