User manual

FPM-3170G User Manual 22
Multiple monitors, serial and USB controllers
1. Run the self-extracting zip file to unzip the files, using the Run
EloSetup option
2. EloSetup will launch. Check both the "Install Serial Touchscreen
Drivers" and "Install USB Touchscreen Drivers" boxes.
3. Review and accept the License Agreement
4. The program will appear to proceed as a single/multiple serial con-
troller installation but USB files will also install.
5. The driver files will install. When the "Setup Complete" screen
appears, you may choose to run calibration (the Elo Video Align-
ment program, EloVA) immediately or wait until later. If you
choose not to run this program now, you can run it from the Elo
Control Panel application. When EloVA runs for the first time, it
will attempt to calibrate all controllers and/or serial ports that were
installed. Press the Esc key on the keyboard to terminate or skip
calibration for any monitor, or allow the program to time out (as
indicated by the progress bar reaching maximum). The program
will continue until all controllers and/or ports have been calibrated.
Silent Install
The EloSetup program for this driver may also be run as an attended or
unattended program from a command line, batch file, etc. Example usage:
To Silent install for USB controllers use
EloSetup /iu /s
To Silent install for a Serial controller on COM1 use
EloSetup /is /P:1 /s
To view all the options available for this installation method, run
EloSetup as EloSetup /h.