User Manual

EKI-6331AN-BE/EKI-6332GN-AE User Manual 42
5.4 Restore Factory Default Settings
The IEEE 802.11n VAC Access Point provides two ways to restore the factory default
settings:
 Restore factory default settings via Web
From “Configuration File”, clicking “Reset” will eliminate all current settings and
reboot your device, then default settings are applied.
Figure 5.4 Restore to Default Settings
 Restore factory default settings via Reset Button
If software in IEEE 802.11n VAC Access Point is unexpectedly crashed and no
longer reset the unit via Web, you may do hardware reset via the reset button.
Press and hold the button for at least 5 seconds and then release it until the
PWR LED gives a blink.
5.5 Reboot
You can reboot your IEEE 802.11n VAC Access Point from “Configuration File” in
“Management” as below:
Click “Reboot” and hit “Yes” upon the appeared prompt to start reboot process. This
takes a few minutes.
Figure 5.5 Reboot