User Manual

EKI-6331AN-BE/EKI-6332GN-AE User Manual 36
4.4 Access Control
The Access Control appoints the authority to wireless client on accessing EKI-
6332GN-AE/EKI-6331AN-BE, thus a further security mechanism is provided. This
function is available only under AP mode.
Open “Access Control” in “Wireless” as below.
Figure 4.4 Access Control
 Profile Selection
Select the VAP profile you would like to enable Access Control
 Access Control Mode
If you select “Allow Listed”, only those clients whose wireless MAC addresses
are in the access control list will be able to connect to your AP. While when
“Deny Listed” is selected, those wireless clients on the list will not be able to
connect the AP.
 MAC Address
Enter the MAC address of the wireless client that you would like to list into the
access control list, click “Apply” then it will be added into the table at the bottom.
 Delete/Clear
Check the box before one or more MAC addresses of wireless client(s) that you
would like to cancel, and click “Delete” or “Clear” to cancel that access control
rule.