User Manual
Table Of Contents
- EKI-6331AN-BE/ EKI-6332GN-AE
- 1 Introduction
- 2 Hardware Installation
- 3 Basic Settings
- 4 Advanced Settings
- 5 Management
- 6 Monitoring Tools
- 7 Status
- 8 Troubleshooting
- A ASCII
33 EKI-6331AN-BE/EKI-6332GN-AE User Manual
Chapter 4 Advanced Settings
AE/EKI-6331AN-BE can automatically adjust proper ACK timeout value by
specifying distance of the two nodes.
4.2 Traffic Shaping
It allows the administrator to manage the traffic flow to ensure optimal performance.
Figure 4.2 Traffic Shaping
Enable Traffic Shaping:
Check this box to control the overall bandwidth for a specific VAP network.
Interface Selection:
Select the VAP network you would like to enable traffic shaping.
Outgoing Traffic Rate:
To specify maximum outgoing bandwidth to a certain rate in kbit/s.
Outgoing Traffic Burst:
To specify the buffer size for outgoing traffic that can be sent within a given unit
of time. The suggested value is 20KBytes. You may just leave the default value
there, and then the connection will be bound to the traffic shaping rule at all
times. You may decrease it to smaller value if the incoming traffic limit is smaller.