User Manual
Table Of Contents
- EKI-6331AN-BE/ EKI-6332GN-AE
- 1 Introduction
- 2 Hardware Installation
- 3 Basic Settings
- 4 Advanced Settings
- 5 Management
- 6 Monitoring Tools
- 7 Status
- 8 Troubleshooting
- A ASCII

15 EKI-6331AN-BE/EKI-6332GN-AE User Manual
Chapter 2 Hardware Installation
3. Connect the power plug to a power socket. The Access Point will be powered
up immediately.
2.2.6 Connect to the Access Point
To be able to configure and manage the Access Point, please do the followings:
1. Open the ferrite core by unsnapping the connector latches. The core will open,
revealing a concave surface.
2. Lay the Ethernet cable into the core, usually within 2 to 3 inches of the connec-
tor. You may have to experiment with the final location depending on the effec-
tiveness of the high frequency abatement.
3. Loop the cable around and through the core. This helps "lock" the core in place,
and may be required in circumstances with severe interference.