User Manual
Table Of Contents
- EKI-6331AN-BE/ EKI-6332GN-AE
- 1 Introduction
- 2 Hardware Installation
- 3 Basic Settings
- 4 Advanced Settings
- 5 Management
- 6 Monitoring Tools
- 7 Status
- 8 Troubleshooting
- A ASCII

9 EKI-6331AN-BE/EKI-6332GN-AE User Manual
Chapter 2 Hardware Installation
3. Slide the cover back and press down the lock button to seal the bottom of the
Access Point.
2.2.2 Using the Grounding Wire
EKI-6332GN-AE/EKI-6331AN-BE is equipped with a grounding wire. It is important
that the Access Point, cables, and PoE Injector must be properly connected to earth
ground during normal use against surges or ESD.
1. Remove the screw on the grounding point at the bottom of the Access Point.
2. Put the grounding wire on the grounding point at the bottom of the Access Point.
Then screw the grounding wire to tighten up.