User's Manual
Table Of Contents
- _
- Chapter 1. Introduction
- 1.1 Introducing the EKI-6311g
- 1.2 Product Features
- 1.3 Package Contents
- 1.4 System Requirements
- 1.5 Inline Power Injector (PoE)
- Chapter 2. Installation and Basic Configuration
- 2.1 Before You Start
- 2.2 Locate the EKI-6311g and Inline Power Injector Ports
- 2.3 Preparing Installation
- 2.4 Basic Configuration
- 2.4.1 Logging into the Web Interface
- 2.4.2 Basic Configuration Steps
- 2.4.3 Set Operating Mode, IP Address, Subnet Mask, Default Route IP, DNS Server IP of EKI-6311G
- 2.4.4 Set Wireless SSID for Wireless Interface
- 2.4.5 Set Wireless Encryption for Wireless Interface
- 2.4.6 Change Supervisor Account & Password
- 2.4.7 pgrade the Firmware
- Chapter 3. Network Topologies
- Chapter 4. All function on Device
- Chapter 5. Specifications
- Chapter 6. Default Settings
- Chapter 7. Regulatory Compliance Information
Chapter 2. Installation and Basic Configuration
This chapter describes the procedures of inst alling the EKI- 6311g.
2.1 Before You Start
After unpacking the system , m ake sure t he following it em s are present
and in good condition. Refer to below pictures for product im age.
1 . EKI - 6311g Outdoor Wireless Access Point/ Client Bridge unit
2 . 100~ 240VAC, 50~ 60Hz AC t o 48V/ 0.375A DC swit ching
adapt er
3 . I nline Power I njector ( PoE) 48VDC, 0.375A
4 . Grounding wire 1.8m
5 . User m anual CD- disc
6 . Wall/ m ast m ounting kit , including one (1) band clam p
7 . Screws
8 . 5dBi Oim i- t ype Ant enna
9 . RJ- 45 cable waterproof cap
1. Unit 2. Adapter 3. PoE 4. Grounding wire
5. CD 6. Wall m ount
7. Screws 8. Ant enna
9. RJ- 45 cable
wat erproof cap
6