User's Manual
Table Of Contents
- _
- Chapter 1. Introduction
- 1.1 Introducing the EKI-6311g
- 1.2 Product Features
- 1.3 Package Contents
- 1.4 System Requirements
- 1.5 Inline Power Injector (PoE)
- Chapter 2. Installation and Basic Configuration
- 2.1 Before You Start
- 2.2 Locate the EKI-6311g and Inline Power Injector Ports
- 2.3 Preparing Installation
- 2.4 Basic Configuration
- 2.4.1 Logging into the Web Interface
- 2.4.2 Basic Configuration Steps
- 2.4.3 Set Operating Mode, IP Address, Subnet Mask, Default Route IP, DNS Server IP of EKI-6311G
- 2.4.4 Set Wireless SSID for Wireless Interface
- 2.4.5 Set Wireless Encryption for Wireless Interface
- 2.4.6 Change Supervisor Account & Password
- 2.4.7 pgrade the Firmware
- Chapter 3. Network Topologies
- Chapter 4. All function on Device
- Chapter 5. Specifications
- Chapter 6. Default Settings
- Chapter 7. Regulatory Compliance Information
39
RF Con nect or
SMA Type
N et w ork ing
Topology
Ad- Hoc, I nfrastruct ure
Oper at ion M ode Access Point / CB+ AP / AP Rout er / CB+ AP Rout er /
HotSpot AP / VLAN AP / VLAN CB+ AP
I nter face One 10/ 100Mbps RJ-45 LAN Port , RS- 232 Console
Secur it y I EEE802.1x aut hent icat or / RADI US client
( EAPMD5/ TLS/ TTLS) support in AP m ode WPA / Pre
Share KEY ( PSK) / TKI P MAC address filt ering Hide
SSI D in beacons Layer 2 I solat ion
I P
Aut o- configur at ion
DHCP client/ server/ PPPoE
Ma na gem ent
Configur a t ion
Web- based configuration ( HTTP)
Firm w a re Upgrade Upgrade firm ware via web browser
Physical Dim ensions 209.1(L) m m * 165.4( W) m m * 61.5( H)m m
W eight AP: 500g ( 1.1 lbs); CB: 600g ( 1.3 lbs)
Environ m ent a l
Tem perat ure Range
- Operat ing: - 10° C t o 60° C ( 14° F to 140° F)
- St orage: - 20° Cto 70° C ( - 4° F to 158° F)
Hu m idit y
( non - condensing)
5% ~ 95% Typical
Pack age Cont ent s
Wat er tight Out door Wireless Client Bridge unit
48V, 0.38A AC/ DC adapter wit h wall- plug power
code
I nline Power I nj ector ( PoE)
User’s m anual CD-ROM
Wall m ounting kit
Mast m ounting kit