User's Manual
Table Of Contents
- _
- Chapter 1. Introduction
- 1.1 Introducing the EKI-6311g
- 1.2 Product Features
- 1.3 Package Contents
- 1.4 System Requirements
- 1.5 Inline Power Injector (PoE)
- Chapter 2. Installation and Basic Configuration
- 2.1 Before You Start
- 2.2 Locate the EKI-6311g and Inline Power Injector Ports
- 2.3 Preparing Installation
- 2.4 Basic Configuration
- 2.4.1 Logging into the Web Interface
- 2.4.2 Basic Configuration Steps
- 2.4.3 Set Operating Mode, IP Address, Subnet Mask, Default Route IP, DNS Server IP of EKI-6311G
- 2.4.4 Set Wireless SSID for Wireless Interface
- 2.4.5 Set Wireless Encryption for Wireless Interface
- 2.4.6 Change Supervisor Account & Password
- 2.4.7 pgrade the Firmware
- Chapter 3. Network Topologies
- Chapter 4. All function on Device
- Chapter 5. Specifications
- Chapter 6. Default Settings
- Chapter 7. Regulatory Compliance Information
4 .2 .2 H ot Spot
（Ca ptive Port a l）
Hot Spot : Enable/ Disable captive port al function. Not e, t he CPE will
becom e rout er m ode and ALL ssid in Access Point role aft er Hot Spot
enabled.
Dom a in: Set dom ain nam e for hotspot.
Prim ar y Radius:
Set prim ary radius server for hot spot user
aut hent icat ion.
Secon dar y Radius:
Set backup radius server for hotspot user
aut hent icat ion.
N AS I D: Set CPE's NAS I D in RADI US fram es.
Calle d St at ion N am e: Set CPE's stat ion nam e in RADI US fram es.
N AS Locat ion :
Set CPE's locat ion nam e in RADI US fram es.
N AS Locat ion I D: Set CPE's location I D in RADI US fram es.
UAM Server: The URL for hot spot user login.
UAM Secret : The encrypt ion key bet ween UAM server and CPE.
UAM Allow e d List : I Ps/ Host nam es t hat hot spot can visit before login.
Figure 4 - 1 1
32