User's Manual
Table Of Contents
- _
- Chapter 1. Introduction
- 1.1 Introducing the EKI-6311g
- 1.2 Product Features
- 1.3 Package Contents
- 1.4 System Requirements
- 1.5 Inline Power Injector (PoE)
- Chapter 2. Installation and Basic Configuration
- 2.1 Before You Start
- 2.2 Locate the EKI-6311g and Inline Power Injector Ports
- 2.3 Preparing Installation
- 2.4 Basic Configuration
- 2.4.1 Logging into the Web Interface
- 2.4.2 Basic Configuration Steps
- 2.4.3 Set Operating Mode, IP Address, Subnet Mask, Default Route IP, DNS Server IP of EKI-6311G
- 2.4.4 Set Wireless SSID for Wireless Interface
- 2.4.5 Set Wireless Encryption for Wireless Interface
- 2.4.6 Change Supervisor Account & Password
- 2.4.7 pgrade the Firmware
- Chapter 3. Network Topologies
- Chapter 4. All function on Device
- Chapter 5. Specifications
- Chapter 6. Default Settings
- Chapter 7. Regulatory Compliance Information
4.2 NETWORK
4 .2 .1 N e t w or k
4 .2 .1 .1 Operat ing Mode - Access Point
I P Assignm ent
DH CP
Choose "DHCP (Dynam ic)" if your router support s DHCP and you
w an t t h e r o u t er t o assi g n a n I P address t o t he AP. I n this case, you
do not need t o fill in the following fields.
Figure 4 - 8
Ma nu al
Ch o o se " Ma n u a l " i f y ou r r o u t er d oes n o t su p p or t DHCP o r i f f o r a n y
ot her reason you need to assign a fixed address t o t he AP. I n this
case, you m ust also configure the following fields.
I P Address
The I P address of the AP on the local area network. Assign any
unused I P address in the range of I P addresses available for t he
LAN. For exam ple, 192.168.2.1.
29