User's Manual
Table Of Contents
- _
- Chapter 1. Introduction
- 1.1 Introducing the EKI-6311g
- 1.2 Product Features
- 1.3 Package Contents
- 1.4 System Requirements
- 1.5 Inline Power Injector (PoE)
- Chapter 2. Installation and Basic Configuration
- 2.1 Before You Start
- 2.2 Locate the EKI-6311g and Inline Power Injector Ports
- 2.3 Preparing Installation
- 2.4 Basic Configuration
- 2.4.1 Logging into the Web Interface
- 2.4.2 Basic Configuration Steps
- 2.4.3 Set Operating Mode, IP Address, Subnet Mask, Default Route IP, DNS Server IP of EKI-6311G
- 2.4.4 Set Wireless SSID for Wireless Interface
- 2.4.5 Set Wireless Encryption for Wireless Interface
- 2.4.6 Change Supervisor Account & Password
- 2.4.7 pgrade the Firmware
- Chapter 3. Network Topologies
- Chapter 4. All function on Device
- Chapter 5. Specifications
- Chapter 6. Default Settings
- Chapter 7. Regulatory Compliance Information
4 .1 .3 Configur a t ion Tools
Figure 4 - 3
Re st ore Fa ct or y Default s - Reset t he CPE's configurat ion set t ings to
the factory default values. Check t he "Rest ore Factory Default
Configurat ion" radio butt on t hen click on APPLY butt on.
Back up set t ings/ Restore set t ings - Check the "Backup
settings/ Restore sett ings" radio but t on then click on APPLY button.
Back up Set t ings - Press t he "Backup Set t ings" butt on to save t he
settings of this device t o a file nam ed "config.bin" on your PC.
Re st ore Set t ings - Restore t he sett ings of t his device to t he backup
settings. Enter the pat h and nam e of the backup file then press t he
"Restore Sett ings" but t on. You will be prom pted t o confirm t he backup
rest orat ion.
24