User's Manual
Table Of Contents
- _
- Chapter 1. Introduction
- 1.1 Introducing the EKI-6311g
- 1.2 Product Features
- 1.3 Package Contents
- 1.4 System Requirements
- 1.5 Inline Power Injector (PoE)
- Chapter 2. Installation and Basic Configuration
- 2.1 Before You Start
- 2.2 Locate the EKI-6311g and Inline Power Injector Ports
- 2.3 Preparing Installation
- 2.4 Basic Configuration
- 2.4.1 Logging into the Web Interface
- 2.4.2 Basic Configuration Steps
- 2.4.3 Set Operating Mode, IP Address, Subnet Mask, Default Route IP, DNS Server IP of EKI-6311G
- 2.4.4 Set Wireless SSID for Wireless Interface
- 2.4.5 Set Wireless Encryption for Wireless Interface
- 2.4.6 Change Supervisor Account & Password
- 2.4.7 pgrade the Firmware
- Chapter 3. Network Topologies
- Chapter 4. All function on Device
- Chapter 5. Specifications
- Chapter 6. Default Settings
- Chapter 7. Regulatory Compliance Information
2 .4 .6 Change Supervisor Account & Pa ssw ord
Enter the SYSTEM > Adm inist r at or page. Figur e 2 - 8 below shows t he
SYSTEM / Adm inist rat or page.
Figure 2 - 8
► AD MI N PASSW ORD Changing
Enter current password in the SYSTEM / Adm inist ra t or / Passw ord
Set ting Curre nt Passw or d field. Ent er new password in t he
“ PASSW ORD and Re - t ype Pa ssw or d” field for changing new
password. Then and click APPLY and reboot t he device.
18