User's Manual
Table Of Contents
- _
- Chapter 1. Introduction
- 1.1 Introducing the EKI-6311g
- 1.2 Product Features
- 1.3 Package Contents
- 1.4 System Requirements
- 1.5 Inline Power Injector (PoE)
- Chapter 2. Installation and Basic Configuration
- 2.1 Before You Start
- 2.2 Locate the EKI-6311g and Inline Power Injector Ports
- 2.3 Preparing Installation
- 2.4 Basic Configuration
- 2.4.1 Logging into the Web Interface
- 2.4.2 Basic Configuration Steps
- 2.4.3 Set Operating Mode, IP Address, Subnet Mask, Default Route IP, DNS Server IP of EKI-6311G
- 2.4.4 Set Wireless SSID for Wireless Interface
- 2.4.5 Set Wireless Encryption for Wireless Interface
- 2.4.6 Change Supervisor Account & Password
- 2.4.7 pgrade the Firmware
- Chapter 3. Network Topologies
- Chapter 4. All function on Device
- Chapter 5. Specifications
- Chapter 6. Default Settings
- Chapter 7. Regulatory Compliance Information
2 .4 .5 Set W ire less Encryption for W ireless I nt e rface
The EKI - 6311G support s 64- bit and 128- bit WEP encryption.
For 6 4 - bit WEP encrypt ion, an encrypt ion key is 10 hexadecim al
characters ( 0-9 and A- F) or 5 ASCI I characters.
For 1 2 8 - bit WEP encryption, an encrypt ion key is 26 hexadecim al
characters or 13 ASCI I charact ers.
Modify t he WEP encrypt ion param et ers on t he web page
“ / W I RELESS/ W i- Fi 1 / W ire less SECURI TY”. Choice “ WEP” Ent er
1~ 15 characters into the W EP Ke y field, then click Apply t o save t he
new param et er and Reboot t he device . Page as shown in Figur e 2 - 7
Figure 2 - 7
17