User's Manual
Table Of Contents
- _
- Chapter 1. Introduction
- 1.1 Introducing the EKI-6311g
- 1.2 Product Features
- 1.3 Package Contents
- 1.4 System Requirements
- 1.5 Inline Power Injector (PoE)
- Chapter 2. Installation and Basic Configuration
- 2.1 Before You Start
- 2.2 Locate the EKI-6311g and Inline Power Injector Ports
- 2.3 Preparing Installation
- 2.4 Basic Configuration
- 2.4.1 Logging into the Web Interface
- 2.4.2 Basic Configuration Steps
- 2.4.3 Set Operating Mode, IP Address, Subnet Mask, Default Route IP, DNS Server IP of EKI-6311G
- 2.4.4 Set Wireless SSID for Wireless Interface
- 2.4.5 Set Wireless Encryption for Wireless Interface
- 2.4.6 Change Supervisor Account & Password
- 2.4.7 pgrade the Firmware
- Chapter 3. Network Topologies
- Chapter 4. All function on Device
- Chapter 5. Specifications
- Chapter 6. Default Settings
- Chapter 7. Regulatory Compliance Information
2 .4 .4 Set W ireless SSI D for W ire less I nt e rfa ce
► W ire less N e t w or k N a m e （SSI D）
When you are browsing for available wireless networks, t his is the nam e
that will appear in t he list ( unless Visibilit y Status is set t o invisible, see
below) . This nam e is also referred t o as the SSI D. For securit y purposes,
it is highly recom m ended t o change from the pre- configured network
nam e. This opt ion is available in the “ / W I RELESS/ W i- Fi 1 / ” page as
shown in Figur e 2 - 6 .
* * D efault SSI D: “EKI - 6 3 1 1 G” in w ifi- 1 .
* * Radio Channel only support s channel 1 t o channel 11 in US A
Figure 2 - 6
16