User's Manual
Table Of Contents
- _
- Chapter 1. Introduction
- 1.1 Introducing the EKI-6311g
- 1.2 Product Features
- 1.3 Package Contents
- 1.4 System Requirements
- 1.5 Inline Power Injector (PoE)
- Chapter 2. Installation and Basic Configuration
- 2.1 Before You Start
- 2.2 Locate the EKI-6311g and Inline Power Injector Ports
- 2.3 Preparing Installation
- 2.4 Basic Configuration
- 2.4.1 Logging into the Web Interface
- 2.4.2 Basic Configuration Steps
- 2.4.3 Set Operating Mode, IP Address, Subnet Mask, Default Route IP, DNS Server IP of EKI-6311G
- 2.4.4 Set Wireless SSID for Wireless Interface
- 2.4.5 Set Wireless Encryption for Wireless Interface
- 2.4.6 Change Supervisor Account & Password
- 2.4.7 pgrade the Firmware
- Chapter 3. Network Topologies
- Chapter 4. All function on Device
- Chapter 5. Specifications
- Chapter 6. Default Settings
- Chapter 7. Regulatory Compliance Information
● ACL for Wi-fi 1
● ACL for Wi-fi 2
● ACL for Wi-fi 3
● ACL for Wi-fi 4
▽ SNMP
● Agent Set t ings
▽ EXI T
Move t hrough t he tree by clicking on an icon to expand or collapse t he
tree. The nodes on the t ree represent web pages that allow viewing and
m odifying the param et ers.
2 .4 .2 Basic Con figura t ion St eps
Note: All setting changing must Reboot the device after click
Apply
This section describes t wo- step BASI C
configuration procedures t o setup
EKI -6311G.
St ep1 : Modify the fact ory- default param et ers on the web page
“ / N et w ork / N et w ork / ”, when changing any param eters, please click
Apply to save t he changes, then click Reboot on the Syst em page.
St ep2 : Modify t he fact ory- default param et ers on t he web page
“ / W ire less/ W i- Fi 1 / ”, when changing any param eters, please click
Apply to save t he changes, then click Reboot on the Syst em page . t o
take effect on the previous configurat ion changes.
13