User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 2.1 Hardware
- 2.2 Connecting Hardware
- 2.3 Reset Button
- 3 Utility Configuration
- 4 Web Interface
- 4.1 Overview
- 4.2 Accessing the Web Page
- 4.3 Overview
- 4.4 Network Settings
- 4.5 Wireless Settings
- 4.6 Port Configuration
- 4.7 Monitor
- 4.8 Alarm
- 4.9 Administration
- 5 Telnet/Serial Console Configuration
79 EKI-1361 & EKI-1362 Series User Manual
– parity n: None Parity.
– parity e: Even Parity.
– parity o: Odd Parity.
– parity m: Mark Parity.
– parity s: Space Parity.
Usage: port [nn|all] mode [vcom|ctrl|data]
Set the serial ports as virtual COM mode, control mode, or data mode.
5.3.3 portadv
$ help portadv
Show port advanced setting.
Usage: portadv [nn|all] delayT []
Set delay time(ms).
Usage: portadv [nn|all] ignorepurge [TRUE|FALSE] dischato [TRUE|FALSE]
dismulticon [TRUE|FALSE]
Enable or disable the feature of ignore purge,
Disable character timeout detection, and disable multiple connection.
Usage: portadv [nn|all] databuf []
Set databuffer threshold.
Usage: portadv [nn|all] rts []
Set port RTS status.
– value 0: On.
– value 1: Off.
– value 2: Toggle by connect.
– value 4: Setting transmission on.
Usage: portadv [nn|all] dtr []
Set port DTR status.
– value 0: On.
– value 1: Off.
– value 2: Toggle by connect.
– value 4: Setting transmission on.
5.3.4 mvcom
Usage: mvcom
Show all serial ports mode and related information.
Usage: mvcom [nn|all]
Set the “nn”
th
or all serial ports as the Virtual COM mode.
Usage: mvcom [nn|all] idleto []
Set the “nn”
th
or all serial ports host idle timeout(S).
Usage: mvcom [nn|all] respto [] framebk []
Set the “nn”
th
or all serial ports response timeout and frame break.
Usage: mvcom [nn|all] bysize []
Set datapackage as size(bytes).
Value 0 : None Setting.
Usage: mvcom [nn|all] bytime []
Set datapackage as time(ms).