User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 2.1 Hardware
- 2.2 Connecting Hardware
- 2.3 Reset Button
- 3 Utility Configuration
- 4 Web Interface
- 4.1 Overview
- 4.2 Accessing the Web Page
- 4.3 Overview
- 4.4 Network Settings
- 4.5 Wireless Settings
- 4.6 Port Configuration
- 4.7 Monitor
- 4.8 Alarm
- 4.9 Administration
- 5 Telnet/Serial Console Configuration
59 EKI-1361 & EKI-1362 Series User Manual
In the Peer for Receiving Data menu, entering “0” as the value for the Local Port will
assign a random TCP Port for an EKI-1361 & EKI-1362 Series device.
Figure 4.25 Peers for Receiving Data
4.6.3.2 USDG Data TCP Server mode
In TCP server mode, the TCP connection is initiated from the host to the EKI-1361 &
EKI-1362 Series device server. This operation mode supports a maximum of five
simultaneous connections for each serial port on an EKI-1361 & EKI-1362 Series
device server from a single or multiple hosts. However a multi-host connection
simultaneously transmits the data from a single serial port.
Figure 4.26 USDG TCP Server Mode
Figure 4.27 USDG Data Mode
IP 192.168.1.1
Ethernet
RS-232/422/485
422/485
P1 WLAN
P2
SYS
EKI-1362
COM 1
TX
RX
1
TX
RX
2
EKI-136X-CE
IP 192.168.1.24
Ethernet
IP
192
.
168
.
1
.
1
SCADASCADA
S
S
S
S
CC
C
A
A
A
D
D
A
A
A
A
A
S
S
C
C
A
A
D
D
A
A
A
S
S
S
S
S
CC
C
A
A
A
D
D
A
A
A
S
S
S
C
C
A
A
D
D
A
SCADA