User's Manual

EKI-1361 & EKI-1362 Series User Manual 58
4.6.3.1 USDG TCP Client Mode
In TCP Client mode, the TCP connection is established from the EKI-1361 & EKI-
1362 Series device server. This operation mode supports a maximum of 16
simultaneous connections for each serial port on EKI-1361 & EKI-1362 Series to one
host or several hosts. You can configure the IP address and TCP port number of the
network hosts connected to the EKI-1361 & EKI-1362 Series device server using the
Advantech Serial Device Server Configuration Utility. After configuring the devices,
when the EKI-1361 & EKI-1362 Series device server receives the data from the serial
port, and the device server connects to the hosts which are configured.
Figure 4.24 USDG TCP Client Mode
In USDG Data TCP Client mode, you may need to enable the peer numbers you
would like to receive. You can set a maximum sixteen network devices to which you
may connect. You need to fill out the IP Address and Port (including local port and
peer port) of each network device to which you want to connect.
By Character-Timeout Click to enable or disable the serial port character timeout
detection.
Peer for Receiving Data
Peer Number Click the drop-down menu to select the number of peers to receive
data.
LocalPort Enter the value of the local port. If 0 is selected, the port is
assigned by the EKI device.
Peer IP Address Enter the address to identify the peer device entry.
Port Enter the port number of the peer device authorized to receive
data.
Apply Click Apply to save the values and update the screen.
Item Description
SCADASCADA
S
S
S
S
CC
C
A
A
A
D
D
A
A
A
A
A
S
S
S
C
C
A
A
D
D
A
A
A
S
S
S
S
S
CC
C
A
A
A
D
D
A
A
A
S
S
S
C
C
A
A
D
D
A
SCADA
Ethernet
P1 WLAN
P2
SYS
EKI-1362
COM 1
TX
RX
1
TX
RX
2
EKI-136X-CE
IP 192.168.1.24
RS-232/422/485
IP 192.168.1.1