User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 2.1 Hardware
- 2.2 Connecting Hardware
- 2.3 Reset Button
- 3 Utility Configuration
- 4 Web Interface
- 4.1 Overview
- 4.2 Accessing the Web Page
- 4.3 Overview
- 4.4 Network Settings
- 4.5 Wireless Settings
- 4.6 Port Configuration
- 4.7 Monitor
- 4.8 Alarm
- 4.9 Administration
- 5 Telnet/Serial Console Configuration
53 EKI-1361 & EKI-1362 Series User Manual
4.6 Port Configuration
The serial port configuration menu has Basic, Operation Mode, and Advanced
Settings.
4.6.1 Basic
The Basic menu allows for the configuration of the serial interface type, baud rate,
parity, data / stop bits, and flow control for port configuration.
To access this page, click Port Configuration > Basic.
Figure 4.21 Port Configuration > Basic
The following table describes the items in the previous figure.
Item Description
Type Click the drop-down menu to select a serial interface: RS232,
RS422, RS485, or RS-485 4-WIRE.
Baud Rate Enter a value to specify the baud rate. The value should conform
to the current transmission speeds of connected devices when
setting the baud rate.
Parity Click the drop-down menu to select the parity: None, Odd, Even,
Mark or Space.
Data Bits Click the drop-down menu to select the data bits: 5, 6, 7, or 8.
Stop Bits Click the drop-down menu to select the stop bits: 1, 1.5 or 2.
Flow Control Click the drop-down menu to select the flow control mode: None,
Xon/Xoff or RTS/CTS
Apply Click Apply to save the values and update the screen.