User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 2.1 Hardware
- 2.2 Connecting Hardware
- 2.3 Reset Button
- 3 Utility Configuration
- 4 Web Interface
- 4.1 Overview
- 4.2 Accessing the Web Page
- 4.3 Overview
- 4.4 Network Settings
- 4.5 Wireless Settings
- 4.6 Port Configuration
- 4.7 Monitor
- 4.8 Alarm
- 4.9 Administration
- 5 Telnet/Serial Console Configuration
EKI-1361 & EKI-1362 Series User Manual 50
4.5.3 Security
To access this page, click Wireless Settings > Security.
Figure 4.17 Wireless Settings > Security
The following table describes the items in the previous figure.
Watchdog The function is used to monitor specific events, which are triggered
upon meeting set conditions.
Disable: Disable the watchdog function.
Disassociation: Once set conditions are met within the
defined Disassociate Timer setting, one of the following
watchdog actions is triggered: Restart WiFi, Reboot, Force or
Re-association.
Ping: The feature pings a specified IP address.
Watchdog Action Click the drop-down menu to associate a response to the
Watchdog event, options: Restart WiFi, Reboot, Force Re-
association.
Disassociate Timer The set value in seconds defining the disassociation period. Once
the condition is met, the defined watchdog action is triggered.
Ping target Enter the IP address to ping when Watchdog Ping is selected.
Ping Waittime Enter a value in seconds to designate the interval between pings.
Ping Loss Counter Enter a value to activate the Watchdog function when the
configured number of ping failure time is reached.
MAC Clone Click the drop-down menu to enable or disable (default) the client
to clone and use the MAC address of the connected device. In
MAC sensitive networks, the function allows to client to overcome
the limitation of the IP-bridged behavior.
Advanced Wireless Setting
Transmission Power Click the drop-down menu to set the transmission power of the
WiFi. By default the AP transmits at full power: Full, Half or
Quarter.
Short Guard Interval Click the drop-down menu to enable/disable the short guard
interval. In 802.11 operation, the guard interval is 800ns. The short
guard interval time is 400ns to allow for an increased throughput.
Apply Click Apply to save the values and update the screen.
Item Description
Item Description
Security Policy
Security Mode Click the drop-down menu to select the encryption when
communication. Available options: None, WEP, WPA-Personal or
WPA/WPA2-Enterprise. If data encryption is enabled, the key is
required and only sharing the same key with other wireless
devices can the communication be established.
Apply Click Apply to save the values and update the screen.